To install the software, download a file in ZIP format. Unzip the downloaded ZIP file to a temporary folder and run the setup application to installm the required software.

ComLab software is free of charge. See "About" for copyright notice and warranty disclaimer.

eProSim - computer simulations for science and technology education.
See description of the software.

eProSim, version 0.98 is fully functional software.
There may be some minor bugs; it would appreciated if these were reported by e-mail to Slavko Kocijancic, slavkok@pef.uni-lj.si.
Compared to version 0.97, the current version has general instructions on using simulations and a short description for each simulation.
To get an e-mail about new versions, go to the Contact section and complete the form under the Guest book.

Download file: eProSim_EN_0_98.zip, 1.36 Mb, version 0.98, April 10th, 2004.

eProLab: a suite of software utilities supporting the data acquisition systems
See description of the software

eProLab, version 1.98.3 supports real-time experiments utilising the data acquisition systems developed within the project. Without a DAQ system connected to the PC, the programme is still capable of opening files comprising real experimental data.

Download file: eProLab_EN_1_98_3.zip, 1.52 Mb, version 1.98.3, March 8th, 2004.

eProLib: programming libraries for the CMC-S3 and H-bridge
See description of the software.

Download self extracting installation file to the hard disk of your PC, open it and the standard setup procedure will start.
Download programming libraries for Visual Basic, version 20. December 2004, 997 kB
Download programming libraries for Borland Delphi, version 20. December 2004, 945 kB

Instructions about the use of programming libraries are available on-line in pdf format:
Instructions for Visual Basic and Excel, 575 kB
Instructions for Borland Delphi, 226 kB

To see detailed characteristics of both IO systems, follow the links below:
H-bridge
CMC-S3